G-Technology G-Speed eS Pro Betriebsanweisung PDF herunterladen (Seite 15)

Using the ATTO RAID Controller

p.15

Using the ATTO RAID Controller

Attach eS Pro to ATTO Controller

Attaching G-SPEED eS Pro to the ATTO R680 RAID controller takes a few easy steps.

1. Shut down your system.

2. Attach one end of the supplied mini-SAS cable to the mini-

SAS port located on the back of G-SPEED eS Pro.

3. Attach the other end of the mini-SAS cable to Port A (left-

most port) on the ATTO controller, as shown at right.

4. Attach the power cord to the back of G-SPEED eS Pro and

connect the other end to AC power.

5. Power on the G-SPEED eS Pro and power on the system.

G-SPEED eS Pro will mount on the desktop.

NOTE: G-SPEED eS Pro is shipped from the factory in RAID 0 mode for best perfor-

mance. The ATTO controller also supports RAID 1, 5, 6, 10 and JBOD modes. Refer

to Change the RAID Mode if you want to change the RAID mode. See RAID Levels

Explained for information on the features of supported RAID modes.

Install ATTO Controller

It is simple to install the ATTO controller, as explained below. Keep in mind that ATTO

ExpressSAS Host Adapters contain components that are sensitive to electrostatic dis-

charge (ESD). Please follow standard methods to avoid ESD.

1. For maximum performance, install the ATTO R680 RAID controller in your MacPro

in SLOT 2 (x16 slot closest to video card).

2. Secure the ATTO controller in place.

NOTE: If you are using a video capture card such as AJA Kona

or Blackmagic Deck-

link

, follow their recommendations for slot usage.

Port A

attach

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 50 51

Keine Kommentare

G-Technology G-Speed eS Pro Betriebsanweisung Seite 15